Interior and bed lighting: courtesy, dome, bed and rock lights

People searching for this call it courtesy lights, interior lights or truck bed lights. Our catalogue calls none of it that, which is the reason for this page: four quite different products sit behind those words, and they cost between $19 and $486.

MapleTorque lists 95 interior and auxiliary lighting products, counted from our own catalogue on 11 September 2026. Prices are ours, in Canadian dollars.

What it is Products Low Median High
Dome, map and courtesy 33 $44 $83 $112
Rock and under-body 35 $167 $292 $486
Bulb replacement 7 $19 $21 $29
Strip and accent † 2

Low and high are the 25th and 75th percentiles. A dagger marks a group resting on fewer than five products — shown for completeness, too thin to draw a conclusion from.

Start with the cheapest question: is it a bulb?

If a dome or map light has simply stopped, the answer is often a bulb, and our bulbs run a median of $21. Swapping a factory incandescent for an LED bulb also makes the cabin noticeably brighter without touching a wire. It is the cheapest change on this page by an order of magnitude, and it is worth ruling out first.

Courtesy and dome lighting

This is the group most people mean. Median $83. These replace or supplement the lights already in the cab — dome, map, footwell, door puddle. Most are direct-fit for a named vehicle, so the vehicle selector matters.

Rock lights are not interior lights

They are the most expensive group here — median $292 — and they mount under the vehicle to light the ground and the wheels on a trail at night. They are sold in sets, they need wiring and usually a switch, and they are an off-road part rather than a cabin one. If your search was about reading a map in the dark, this is not the group you want.

Bed lighting

Bed lights are strips or pods that mount under the bed rail so you can see what you are loading. They come up under the same searches as cabin lighting but solve a different problem, and they generally need a power source and a switch.

Common questions

Will LED bulbs work in my factory fittings?

Usually, if the base type matches. Some vehicles monitor bulb current and will report a fault with a low-draw LED; the product page notes where that applies.

Do rock lights need a professional install?

Not necessarily, but they need a fused power feed, a switch and a route for the wiring that survives water and road debris. It is more work than a bulb swap.

Are these prices a quote?

They are our listed prices, counted on 11 September 2026. The product page is always the price.

Back to blog